About Me

ME2029 Design of Jigs, Fixtures and Press Tools Mj2014 Question Paper

Sponsored Ads:

Quick Links
University Papers University Syllabus Entrance Exam
PSU Papers Bank Papers Placement Papers
VTU Anna Univerity Syllabus Anna Univerity Papers
Anna University Question Paper Code : 11049
B.E./B.Tech. DEGREE EXAMINATION, MAY/JUNE 2014: 
Seventh Semester 
Mechanical Engineering 
080120043 — DESIGN OF JIGS, FIXTURES, PRESS TOOLS AND MOULDS 
(Regulation 2008) 

University Papers | Syllabus | Entrance Exam | Govt & PSU Papers | Bank Papers

Programming Questions | Travel Tips | Mobile Review | Placement Papers | Books

ANNA UNIVERSITY SYLLABUS: CLICK HERE

OTHER DEPARTMENT PAPERS: CLICK HERE

Download PDF File - CLICK HERE



For More Question paper of MECH - CLICK HERE

PART A — (10 x 2 = 20 marks) 

1. Which type of work pieces often need more than six locating points?
2. What are the important properties required for clamps?
3. What are liner bushes?
4. What are the main types of boring fixtures?
5. Differentiate a compound die and a combination die
6. Why back-pin die sets are preferred for lateral feeding?
7. State the advantages of V bending.
8. What is ironing effect in drawing?
9. What is the use of chase in compression moulding?
10. State any two factors that decide the operating temperature of a mould.

PART B — (5 x 16 = 80 marks) 

11. (a) Write short notes on the following locators : (i) V-locator (4)
(ii) Profile locator (4)
(iii) Diamond pin (4)
(iv) Equalising jack. (4)
Or
(b) (i) Explain the various principles involved in clamping. (10)
(ii) Write a note on clamping force. (6)

Post a Comment

0 Comments